Metal Roof Gable End Trim Installation

Rake trim also known as gable trim is a metal flashing finishing piece placed along the roofline at the sloped sides at the end of a residence s dormer or gable.

Metal roof gable end trim installation.

The edging or eave flashing consists of metal strips that are used to cover the perimeter of the roof. You can see what a nice clean look it provides. We have our z trim installed and tape seal on top of the z trim so we can install this and put it up against the wall. How many do i need.

Apply the tape seal to the top of the z just as we have at the eave and other places of the roof. We are ready to install the gable trim using pop rivets with tape seal in between the gable trim and the z. The peak of your metal roof needs a different trim from the gables. Gable trim creates watertight transitions in the critical locations where the roof s slope or direction changes.

I m going to install one between each. Two slopes meeting on your metal roof need their own metal trim to bring them together safely and cleanly. Rake trim can be flat with no overhang or it can overhang the gable end like an eave. You can also use pop rivets.

If this type of trim is used it is important to properly seal sealer tape is commonly used and fasten the cladding sheet along the gable to prevent water from migrating under the sheet and into the building. The edge of your metal roof needs a different trim than the peak of your metal roof. To install gable trim fit the pieces in place fastening through at 36 spacing maximum both top and bottom nail ing fanges. Gable trim buy metal roofing direct 10 long length 26 gauge metal installs at the rake end of the roof matches the color of the panel use with tacky tape.

The final thing to do is install the end wall trim. We have a one inch bend down on either gable and we can fasten this using stitch screws. Use your 1 1 4 in 3 2 cm nails to secure the flashing to the subroof. Gable trim serves an integral role in strengthening and sealing your entire roof system.

Add up the total amount of gable of the roof and divide by 9 5 10 long length. There are two finish details on the gable trim that we are going to show. It should overlap the edge of the gutter if you have them.